Skip to content
Shop tools

Drill speed calculator

Pick a bit and a material for a starting drill press speed.

A fraction like 3/16 or a decimal like 0.1875.

Bit type

1084, 1095, O1, 80CrV2

Drill press speed

760 RPM

Range 610 to 920 RPM

1/4" (6.35 mm) · HSS · High-carbon steel, annealed
Based on 40 to 60 SFM (12 to 18 m/min)

Tips

  • Cutting oil on the bit, and a steady feed that makes a curl: a bit that rubs only dulls itself.
  • Drill pin and lanyard holes before heat treat, while the steel is soft.
  • Center-punch the mark first so the bit starts where you want it.
  • On holes deeper than about three times the bit's width, peck: drill a little, lift out to clear chips, repeat.

Starting points for a drill press, from machinist handbook and woodworking chart figures, set on the slow side and kept between 250 and 3,000 RPM. Start slower for larger bits, and use cutting fluid on metals. If the bit squeals or smokes, or steel chips turn blue, slow down.

Reconnecting… Hang on, we're getting you back. Paused This tab was asleep. Pick up where you left off. Can't reach JHu Masterclass Check your connection. We'll try again when you're back online. This session has ended Reload the page to carry on.